Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - amazingmrg

Pages: [1]
General Discussion / Re: First Impressions
« on: September 01, 2015, 03:47:45 pm »

That said, everything has now arrived and been assembled.  Everything more than lives up to my expectations (the Wulfkin were a dream to put together!)  Next stop: painting!

General Discussion / First Impressions
« on: August 20, 2015, 05:38:42 pm »
While I'm waiting for my KS stuff to arrive I was just wondering what are peoples first impressions of everything?  The pics that have been released look amazing and I really like the graphic design of the rulebook.  Can't wait to hold it in my hands!

Errata / Re: Chapter 1
« on: February 27, 2015, 11:12:15 am »
•   Penalty/X – this penalty lowers the value of the given attribute by X, down to a minimum of 1.

I think this could do with an example.  If it works like I think it should, then maybe something like "MOV/2 would represent a penalty of 2 to the models MOV attribute."

Also, maybe rearrange the order slightly.  Move sections 1.5 and 1.6 forward (to 1.4 and 1.5 respectively) and move 1.4 to 1.6.  This way the rules flow from Dice -> Distances -> Attributes -> Penalties.  It seems a little more logical to me and works better with the change above.

Errata / Re: Chapter 1
« on: February 10, 2015, 05:23:37 pm »

The game uses ten-sided dice, D10 for short. A 3D10 notation means you are to roll three dice. Each result of 10 allows you to roll an additional die in that test. These dice can generate further extra dice, to a maximum of 10.  No single roll may exceed more than 10 dice.

There are two basic types of tests, or rolls, that you might be called upon to make:


There are two basic types of tests, or rolls, that you may be required to make:

•   Standard Test – roll a number of dice equal to the models attribute being tested. Each result equal to or higher than the Difficulty Level generates one success. Each result lower than the Difficulty Level generates one failure. Regardless of what the difficulty level is, a result of 1 is always a failure, while a 10 is always a success.
•   Opposed Test – an Opposed Test occurs when two or more models belonging to opposite armies carry out the same action trying to achieve opposite effects. In such a case, each player rolls a D10 and adds the value of his models attribute being tested. For each result of 10, the player can re-roll the die and add the result to the total. The player with the highest total wins. In case of a tie, repeat the test until one side wins.

A player may never roll more than 10 dice during a single standard test. If the number of dice to be rolled would exceed 10, reduce it to 10 before rolling. This could then be completely removed, unless the intention is that Opposed rolls can have more than 10 dice?

Errata / Re: Chapter 1
« on: February 10, 2015, 05:10:14 pm »
Let's start off with an easy one! 

1.1 KeyWords - I would recommend changing the title to Keywords (no upper case W).  I just think it looks better!

Pages: [1]